ARC LED LAMP

Beschreibung

Product description: Inner width of the arch: 100cm External width of the arch: 116cm Height of the arch: 74 cm The width and height can be adjusted by a straight module - it has a length of 13cm The arch has two routes prepared for placing the LED strip - one is placed so that the LED strip is not visible but shines on the wall where this light will be placed. The second LED strip points downwards to illuminate the work surface. The entire project is prepared so that it can be printed without support, as it is - only at the base I recommend printing with support, it is possible without them, but the internal space tends to make fibers - supports are a better choice. I intentionally did not prepare any power inputs - just drill a hole of the correct diameter in one of the side panels. On the other hand, the switch panel is prepared for 5 switches or also full for drilling your own hole. 5 switches therefore, if you would like to use a programmable WS2815 LED strip, a WLED ESP32 controller and a Shelly I4 DC module for sending other programmed scenes – this is how I installed the light – but the Shelly module is not necessary at all if you do not want another physical person – the ESP32 controller only has on and off. I highly recommend printing from PLA, I printed it from PETG and because PETG is quite flexible, when I added a central straight module to increase the width of the arc, there was already some deflection, however, without the central module, PETG will work just…