Raspberry Pi 3/4 DIN Mount

Beschreibung

Based on the ingenious design by jwags55. This remix is designed to fit more modern Raspberry Pi's (3 and later). The... Based on the ingenious design by jwags55 . This remix is designed to fit more modern Raspberry Pi's (3 and later). The tolerances were tightened up so it should be a tight fit on 35mm DIN Rails and hold the board securely. Also this mounts the boards slightly closer to the rails. Note: It's really easy for me to tune the parameters so if it's too loose/tight let me know in the comments and I can make some adjustments. Features Snap fits to DIN and Board (No screws needed) Works with PLA Low profile No tools required Easy and fast to print (No supports) Printing Tips Use 4 perimeters 4 top/bottom layers 20% gyroid infill 20% Gyroid infill Print Settings Printer: BLV Cube Rafts: No Supports: No Resolution: 0.2 Infill: 20% Filament: Radio Shack :-) PLA Blue Notes: I always printed these in PLA. PETG would probably be more durable and longer lasting. Category: Electronics