Deadpool Gearstick

Beschreibung

The most awesome gearstick for your car you could ever have!!!! The most awesome gearstick for your car!!!! This was originally designed to fit on a Peugeot 206 gearstick but should fit others. Its a push fit for a 11mm gear shaft so if the shaft you are fitting this to is this size then you are in luck. this may fit onto a 10mm shaft also as it was very tight when I fitted mine, but you want it to be as tight as possible so there is no risk of it coming off whilst you are driving. The depth of the hole is 75mm so Lots of pushing and turning is required. There is a groove around the bottom of the base to fit the gearstick gator into to give that nice finish. Print settings 0.1mm, 0.2mm and 0.3mm layer heights are possible it just depends on the amount of post processing work you want to do after printing. 5 walls minimum I printed mine with 7 walls just to give extra strength so that it wouldn't break when either fitting or in use of the car. 50% minimum infill again this is to give strength but also some weight. Filament I used PLA for my print but would probably recommend PETG as it holds up better in hot environments, but with that said this was in my car for 3 years through all seasons with no warping or breaking and when it came time to get rid of the car took a lot of struggling to remove it. Painting I used several thick layers of acrylic paint to colour and about 5 layers of spray lacquer. this was to help smooth out the layer lines, to help protect it from constant…