Ender3 Hotend Improve

Ender3 Hotend Improve

Kostenlos STL Sonstiges
  • 13 Aufrufe

Dieses Modell wird auf Cults3D gehostet. Dateien, Bilder und Lizenzangaben gehören dem ursprünglichen Designer.

Auf Cults3D ansehen ↗

Beschreibung

The block of blowing coldend has been raised higher (approximately 10 mm) so that the cooler does not blow around the hotend. A PCB separator has also been added inside the casing to eliminate drafts. This part is necessary for blowing plastic. Tested with ABS plastic. Covered with foil to reflect part of the heat from the hot end Using aluminum tape is an experiment! Aluminum scotch tape is used to limit the effects of heat from the hot end to slow plastic degradation and deformation of the part. As practice has shown, sticking should only be on the side facing the hot end.

About this model

Ender3 Hotend Improve is a kostenlos 3D model in the Sonstiges category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

Ähnliche Modelle