AUS Friendly Dry Spool Stackable Storage System

Beschreibung

AUS Friendly Dry Spool Stackable Storage System Decor 6ltr Cake Container Lazy Susan bearing NItto Electrical Tape (Extra sealing) Spool Holder and Spool nut fit most spools while the small spool nut is for Wanhao/Cacoon create spools. Holes for spool holder are 5mm, so the lazy susan bearing holes needed to be drilled out as the low profile screws from Makerstore are 5mm. Use whatever hardware you see fit. Assembly 1. Drill bearing for 5mm screws 2. Mount the holder to the bearing, make sure you use low profile screws or they will touch. 3. Mark out the holes for the lazy susan bearing in the bottom of the cake container and drill 4. Put Nitto tape over the holes cut to allow the screws through. This is to give a better seal. 5. Mount the holder in the cake container. 6. Put nitto tape around the rim of the container. 7. Mark and mount the exit hardware. I used http://www.thingiverse.com/thing:487789 8. Install the filament, feed through the hole and put the lid on. Will be a very firm fit with the tape. 9. Stack, use and profit.