Orientable stand for video projector

Beschreibung

Designed as a stand for the awesome XGIMI Elfin Portable Videoprojector whose size is 19.2 x 19.4 x 4.8 centimeters and weights less than 1kg. But the stand can probably bear heavier devices, just not sure how heavier. The most difficult part when designing this was naming the parts because I lack the vocabulary :) so bear with these silly names: You will need to print two “baseRod.stl”, two “flank.stl”, two “sidePole.stl”, two "pivot.stl" and two “pivot(1).stl”, one “tray.stl” The pivot is a big printed screw, printed in two halves horizontally rather than one vertical print so that the layer orientation make it sturdier. You need not glue them to use them. Just put one “pivot.stl” along with one “pivot(1).st”, and screw in the “sidePole.stl” threaded hole. Caution: Do not tighten much, you may be unable to unscrew it if needed without breaking all. Add a drop of oil to make it smoother. Assembling using hex 4mm nuts and bolts: Two M4*8mm to block the position Four M4*20mm to assemble to bottom rods to the side poles. Six M4 nuts. And 2 to 6 self tapping M2*8 screws to assemble the tray and the flanks (I designed 3 holes on each flank, but used just one screw and it was enough)