Cleaning station for Anet A8 Plus

Beschreibung

This is a mount which allows an automated nozzle cleaning station for the Anet A8 plus. It uses the head of a cheap copper brush which simply slides into place. If you have a later (v2 or later) version of Marlin, you can use the built-in G12 command to run a clean. If not, you can easily enough create a few lines of GCODE to integrate into your prints to perform the cleaning cycle. The brushes used were these from AliExpress. You just need to cut off most of the handle, leaving some to more easily replace the brush https://www.aliexpress.com/item/4000800461237.html See my blog for more details https://a8plusupgrades.blogspot.com/p/contents.html