Corn Hole Wall Bracket

Beschreibung

I designed these to hang my cornhole board in my garage. They are probably over engineered but my boards are heavy (3/4 in plywood deck and 2x4 sides) and I didn't want to risk them falling off the wall. When hanging them make sure to use washers and mount the hangers into studs.Printing:I printed these with a 0.6mm nozzle with 3 perimeters, 4 top and bottom layers and 25% Gyroid infill and 0.30mm layer height. This is probably overkill but my cornhole boards are heavy and I didn't want them falling off of the wall.If you are printing with a 0.4mm nozzle then I recommend increasing the perimeters to 4-5 and top and bottom to 5.