打印机架子 Printer Stand

Beschreibung

打印机需要叠放，但是找不到刚好适合的跨距支架，就自己设计了一个。这个架子跨距外尺寸40cm，内尺寸37cm，前后幅宽25cm，刚好可以扣住市面上大多数的激光打印机（激光打印机通常款37cm，高26cm）。架子比较大，只有v3plus，K2pro，K2Plus，单色K1max可以打印。横梁长40cm，在300盘必须45°斜置才能刚好在盘内。两侧的立脚置中放置就行，由于立架高度设计的29.8cm，接近盘面极限，切片软件一定会报超出范围，但是我拿v3plus和K2pro各打了一片，都可以正常完成打印。封面图使用提供的3MF设置打印，每格配件要打印2个，这个模型没有特殊的结构，按自己的打印习惯切片就行，耗材根据自己的情况调整，对强度有需求的话建议提高填充比例。安装方法：将立架立在两侧，把横梁的插销扣入立架的销孔，最后把两片面板装上即可，需要增强强度的话可以涂点502。使用后如有改进建议欢迎留言交流。A custom bracket was designed for stacking printers when no suitable span bracket could be found.This bracket has an outer span of 40 cm, an inner span of 37 cm, and a depth of 25 cm. It is quite large and can only be printed on the v3plus, K2pro, K2Plus, or single-color K1max. The crossbeam is 40 cm long and must be placed at a 45° angle on a 300 mm build plate to fit. The two side uprights are centered. Since the upright height is designed at 29.8 cm, close to the build plate limit, the slicer will definitely warn of exceeding the range. However, one piece was printed on both the v3plus and K2pro, and both completed successfully.For the cover image, print using the provided 3MF settings. Each component needs two copies. This model has no special structural requirements; simply slice it according to your usual printing habits and adjust filament as needed. If strength is a concern, consider increasing the infill density.Installation method: Place the uprights on both sides, insert the crossbeam's pins into the pin holes on the uprights, and finally attach the two…