Cat Side Table

Beschreibung

Adorable little plate/table that can be printed to act as a plant stand, a small corner table, or in smaller versions for holding jewelry, or a catch-all plate for keys, pens, etc. It was built for an Ender 5 Max, so it is very large - the cat stand alone is a full 400mm tall. The plate makes it even larger - roughly 440mm. The plate is also 180mm across at default size.There are two separate parts to be printed to reduce the amount of support needed. Some support may still be needed on the large cat's chin and the little one's belly. Recommend setting your Support Object First Layer Gap or Top Z Distance to .5 (default is .2) so the supports are a bit easier to remove later.Can be printed in almost any filament.