Rear View Mirror Phone Mount

Beschreibung

You will need your own phone mount, e.g. magsafe mount or friction mount, etcClip (to mirror post) - Print in TPU so you can easily mount it. There is two versions if you want to use actual hardware as the hole is 5mm in diameter or print the included bolt/nut. I had some hardware from another mount that broke so I scavenged the bolt and nut to use on the clip. Clip V3 is for larger posts. The extension, short/long, ball should be printed in a material that can withstand the summer heat inside a car. TPU, PETG, ABS?I used higher infills and at least 3 lines for wall count. I tried to incorporate the ball/extension/long pieces as one unit but when I printed out it snapped off when I dropped it on the floor so I designed it as three separate pieces.