Magic The Gathering - Jumpstart Cube

Beschreibung

I wanted a nice looking box to hold my Magic the Gathering Jumpstart Duel packs without angering the wife with cards all over the table. I designed this to look nice on the table while also being functional for when my daughter, her friends, or I play. I have been using the locking jumpstart reusable pack from Libery300 (linked below) to hold one jumpstart pack in sleeves. You can use this without the reusable packs but I made this box to support those packs which also keeps it a blind draw. The idea is simple I put 12 jumpstart packs into cheap gamestop sleeves and place them inside the reusable packs. You roll the dice to choose which 2 jumpstart packs are combined to make the deck. Lastly you play! How I solved the same color jumpstarts shuffled in same color sleeves is I used a black fine tip sharpie and touched the same corner on the back of the sleeves for that jumpstart pack (a different corner for a different same color pack). While it is marking the card sleeve, you can only see the mark under bright light up close. That dot makes it easy to un-shuffle the cards back into their pack. Printer specifics Printer Anycubic Kobra S1 0.4 nozzle 0.2 layer hight 2 walls 15% infill You can use this with or without a multi-color printer as this is designed for layer hight My print time for the box is roughly 16 hours I use roughly 600g of filament with the total cost around $12 bucks. This print has very tight tolerances so I would put the lid on and remove it a couple times…