Patch Cable Organizer by Said

Patch Cable Organizer by Said

Kostenlos STL Werkzeuge
  • 12 Aufrufe

Dieses Modell wird auf MyMiniFactory gehostet. Dateien, Bilder und Lizenzangaben gehören dem ursprünglichen Designer.

Auf MyMiniFactory ansehen ↗

Beschreibung

Patch cable organizer. You could use it for your breadboard prototype or any other short cables. Gap between rails is 1.8mm in drawing, it could be different after you print (under/over-extrusion, steps calibration etc.) Generally if your cable tip is larger than 1.85 I expect it should stay in place and not fall off. I printed this with eSUN PLA and it's flexible and strong enough. Printing orientation is important. You will need supports which can be broken easier. Adjust support Z distance accordingly. I broke most of it with my fingers but the last parts I had to remove with exacto knife, took couple of minutes. | Download free and paid 3D printable STL files

About this model

Patch Cable Organizer by Said is a kostenlos 3D model in the Werkzeuge category, shared by the MyMiniFactory community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on MyMiniFactory. Use the button above to open the original page and download it.

Ähnliche Modelle