Pen Plotter

Beschreibung

You can replace the spring with an original spring, not a printed one, for maximum results.Change the nozzle diameter to 0.2mm.Layer height to 0.2mm. Since our design is 0.2mm thick, this makes it a single layer print.Wall thickness to 0.2mm.Wall line count should be 1.100% infill. (Doesn't matter)Set Printing and Build Plate Temperature to 0.Make sure Enable Retraction is checked.Check Z Hop when Retracted and set Z Hop Height to 0.4mm. This lifts the pen by 0.4mm when moving from one point to another.Uncheck Enable Print Cooling.Set Build Plate Adhesion Type to None.These settings are applicable for both the methods. If you are using the 2nd method, then you probably need to scale the model in the slicer to get the dimensions right. Uncheck Uniform Scaling (so that Z does not change) and adjust X and Y scale.Hit slice, save the g-code, and run it on the printer.see more on YouTube