Moving V8 motor engine - Dancing Queen

Beschreibung

This is a motor with a v8 configuration. It has two halves mounted ninety degrees from each other with the same crank shaft, connectors and pistons as the four cylinder just more of them. It is worth noting that they can be alternatively mounted flat or opposing piston configuration.I have added the crank shaft parts layout and the source file as separate files so if any parts brake, you don't have to print the whole thing again.Instructions:Use the file marked v8 layout fixed and V8 body #2 for plate printing.The pistons mount to the connectors with 3mm filament.It helps to put the crank shaft together without the ends that it pivots on first, don't forget to put the pistons on as you go.Then put the piston and crank assembly in the cylinders and glue the blocks together. The cylinder blocks mount on each others end but note their is a rounded corner, this is for a nice feel in your hand when holding the motor.Finally I put in the two small rods that the whole thing rotates on and the crank handle.Your done!