Elegoo Centauri Carbon 2 Dry Box Enclosure Frame

Beschreibung

I made a frame for a dry box enclosure for the CC2. I had some 5.8mm thick plexiglass around and used that for the walls. The enclosure is attached to the machine with 2 strips of adhesive velcro from the dollar store so it is removal. The hold is surprisingly strong to where I didn't even need the feet I was planning on designing. I used some leftover soft side of the velcro along the edges of the plexiglass that is against the machine to avoid scratching and knocking sounds but you would be better to use weather stripping or foam.The magnets were just 8mm diameter ones 2mm thick. I also installed 4 PTFE tubes and push fittings to connect the dry box directly to the AMS (this was finnicky).I printed the whole thing out of Elegoo Rapid PETG (I used white because I had a whole spool I wasn't using but I regret not doing it in black haha). I also designed and made a printed a little magnetic cage to stick to the side of the machine that can hold a bunch of those desiccant pouches you get with spools. I had to manually cut and shave the lengths a bit to make everything fit snug so I wouldn't use my models as 100% gospel.Lastly, to make all the filaments fit within the smaller footprint you will need 4 of the 65mm CANVAS spool brackets (2 of them mirrored) from https://www.thingiverse.com/thing:7285439