Sidewinder X1 V4 - Left X-Axis Cover by Code and Make

Beschreibung

I found that the left cover shared by Crossfire3D did not fit my Sidewinder X1 V4. Next I tried chanh55's design which fitted much better but it required supports and I found that it slightly rubbed against the X-axis pulley wheel of my printer. So I created this remix of chanh55's design: The logo has been removed so that it can be printed without supports The bottom-right corner has been modified to clear the X-axis pulley wheel It has been rotated onto the side it should be printed on This design is completely free and shared under a permissive license. Your support is hugely appreciated. Did you know? Some of our designs cannot be found on MyMiniFactory. If you are looking for more, check out our premium projects: https://codeandmake.com/premium Update - 1st December 2020 By request, we've added a selection of 'extended' versions. Please note that the extended versions are untested. This means they may not all fit your 3D printer. The sizes represent the (approximate) size of the front and rear of the cable slot. The original version shown in the photograph, it is x-axis_cover_-_left_v8_without_logo.stl. If you need another size that isn't listed, please post a message in the comments and I'll add more as soon as possible. Printing Recommended slicer settings: Resolution: 0.1mm - 0.2mm Infill: 20% - 50% Supports: Doesn't Matter Rafts: Doesn't Matter Right cover? For a right cover, check out this one by venegade. Attribution This work, "Sidewinder X1 V4 - Left X-Axis…