Str8 Jacket by DIMLab

Beschreibung

How much fun is this!? Put a ball bearing in the cube and tip it around to guide the ball through the three-dimensional maze. You can watch a video of game play in this Youtube video of a 3-by-3-by-3 maze or this video of a 5-by-5-by-5 maze. In fact, if you're looking to try a DIMLabyrinth for the first time, we'd recommend the 5-by-5-by-5 Cube-asaurus Rex. You want to try this? Really!? Are you out of your Vulcan mind? This is an epic challenge. Be sane and go back to some of our simpler DIMLabyrinths. You see, the path in this bad boy passes through all locations in a 8-by-8-by-8 cube (that's 512 locations!). A continuous path connects the entrance to the exit but this one includes dead ends to elevate the frustration level. The starting hole at the entrance is marked with an "S" and the exit hole at the end with an "E". For a lesser challenge, try almost anything else. Of course, a DIMLabyrinth of smaller dimension would fit into this category. Please visit our DIMLabyrinth site! Or visit our DIMLab site! Technical stuff: - This print requires no supports and can be prone to stringing. If you do not have a way of melting the strings (a hair dryer potentially), slide a #2 pencil through each set of holes to clear the paths. - Each maze is printed with an 0.2 mm layer height with 10% infill and 3 walls. - On larger mazes, good bed adhesion is needed to keep the corners from peeling up. If you have a glass bed some glue from a basic glue stick will help improve adhesion as…