Ender3 electronics case remix

Beschreibung

A remix for the great electronics case from TeachingTech. This extends below the printer, and assumes you have your printer on feet Below detail some of the changes I made: - Made the lid openings the same size, since I use this on the front of my printer, with a PSU mod occupying the back of my printer. - The box itself has also been made thicker with 3mm to give them some more rigidity. - Recessed the front center bolt hole - Added 0.2mm spacing between the box joint and lids (because 3d printers aren't the most accurate) - Made holes 2.8mm because I want the nuts to thread in fairly snug. This may struggle with PETG. You may need to drill them out to 2.8mm - Reduced the height of the boxes at the top by 0.5mm so they don't fit quite as tight and bend the lids due to that.