USED CARS DEALER DIORAMA FOR 1/64 SCALE DIECASTS (HOTWHEELS) by PA1

Description

Mini car dealer diorama to display your 1/64 diecasts, especially designed for FDM printing. Everything prints fine, and is designed in fonction of layer heights and widths. Modular, very easy to print, this one requires just a few supports.Everything is already placed in the right position. The kit contains everything you see on the pictures (except cars :p). Other kits on my profile. Easy to assemble, simply use glue:-Assemble the base first as shown on the pictures.-Assemble the office, then the porch-Put everything together. If you wanna put lights inside the office, there's a cable duct inside the ceiling to do so. It is accessible through the small hole in the roof, at the base of the electric mast. If you choose this option, i suggest not glueing the roof to the office for further access. For the flags, i used a simple sewing thread and slide the flags on it. For the lighted version: I have used a LED Fairy string instead of the sewing thread/flags. Pretty easy to find on Amazon. NOTE 1: For the two signage, i suggest that you change your line width in your slicer to 0.35 (instead of 0.4 or 0.45). This will give you the best results. NOTE 2: The long wall (brick wall) is printed on its back. Square holes are gonna need bridges and because of that (if your settings are not optimal) the holes may be tight a bit. I have included two post versions. One is a little smaller, so if the first one is too tight, before losing time printing another brick wall, try to print the…