Extrude Mod by Mitchell O'Brien

Description

here is an easy print box mod i have designed for use with a single 18650 battery, i have listed below all parts that have been used to wire and connect it up to a fully functional "mechanical" mod it functions like a mechanical in the power will go down as the battery dies, but when using the parts listed below, it has reverse polarity protection, low voltage protaction and will not fire any higher than 50a. similarly the cutouts for the 510 and the button are also for the parts below, but for note the switch hole on right side is 12mm and the 510 is 10.5mm (space for an m10 thread) switchfet v2.5 -http://www.modmaker.co.uk/Switchfet-V2.5 (mosfet) switch -http://www.modmaker.co.uk/12mm-Stainless-Steel-Clicky-Switch-With-Flat-Flush-Actuator?search=12mm%20Stainless%20Steel%20Clicky%20Switch%20With%20Flat%20Flush%20Actuator 510 connector -http://www.modmaker.co.uk/Fat-Daddy-Vapes-510-V3-Short-Body?search=Fat%20Daddy%20Vapes%20510%20V3%20Short%20Body i used the contacts from one of these sleds -http://www.modmaker.co.uk/Blossom-1048-Dual-18650-Battery-Holder?search=Blossom%201048%20Dual%2018650%20Battery%20Holder the wiring diagram for the mosfet is included on the site linked, the drip tip included is made to fit this blank (not needed but looks pretty :D) -http://www.modmaker.co.uk/510-Drip-Tip-Blanks-10mm?search=510%20Drip%20Tip%20Blanks%20%2810mm%29 NOTEdealing with electrics and batteries is dangerous, please use utmost caution when building this, and triple check every…