Infinity Hanger (Shoe Hanger) - Invisions3D Tech

Description

Solve your shoe clutter with the Infinity Hanger! An innovative hanger design that allows the de-cluttering of footwear is the forefront of the Infinity Hanger. Tested weight capacity of 52Lbs(23.5KG) without any damage! The arms are slightly textured to add extra grip to the item but not too much where it can damage the hung item. The design will also allow a diverse use case as long as you can fit the item between the arms.This is for two hangers that fit very well on the 220x220 build plate for the CR-10 SE. You can delete one or add as many as you wish.Filament used: Elegoo Rapid PLA PLUSDefault Hyper PLA settings besides the following in Creality Print (most settings are changed for the higher speed that works for the stock CR-10 SE with the Elegoo Rapid PLA PLUS)Shell->Top Surface Skin Layers->1Infill->Infill Pattern->GyroidInfill->Infill Layers Combination->Check BoxSpeed->Print Speed->550.00 mm/sSpeed->Initial Layer Print Speed->100 mm/sSupport->Generate Support->Check BoxSupport->Support Structure->Tree SlimSupport->Tree Support Branch Angle->50% (makes it easier to remove supports in my opinion)Support->Enable Support Brim->Check BoxSupport->Support Brim Line Count->10Material->Printing Temperature->270.00CMaterial->Initial Printing Temperature->240.00CMaterial->Final Printing Temperature->185.00CBuild Plate Adhesion->Build Plate Adhesion Type->NoneExperimental->Infill Travel Optimization->Check BoxExperimental->Fuzzy Skin->Check BoxExperimental->Fuzzy Skin Outside…