Plant Pot Insert

Description

This is an insert for plant pots that has a hole at the bottom for drainage. Insert this thing in a beautiful plat pot that has no drainage hole. You basically plant your flower/plant/succulent directly in here and then place the thing in your pot. This thing is not visible once it's inside your pot. I've also included a bottom support to keep the plant and earth away from the pot so that the drainage will actually work. IMPORTANT: There are two models of the insert, one a typical 3D model while the other one is for use in "vase mode" or "spiral vase mode". Vase mode prints much faster and yields a sturdy enough part for use as an insert. ALSO IMPORTANT: You need to pay attention to two (2) little things: 1. Drill a hole at the bottom of the insert (or punch it with a blunt instrument!) for drainage 2. Install the bottom support the right way, with the drainage cutouts at the bottom (as shown in photos). Not a huge deal if you place the support upside down, but the idea is to let any drainage water flow to the entire bottom surface of the pot. The little arms/stars are there to center the part in the port.