【国际站】

Description

This is a full upgrade kit for the Creality Ender V3 KEIncluded:Upgraded Filament holder to reduce line jerking (3 walls, 20% infill)Nebula Cam holder & included toolkit holder (4 walls, triangular 35% infill)Waste tubs with a built-in retaining clip for the extruder cable (2 walls, 100% infill)Filament guide for extruder (2 walls, 25% infill)Gantry supports to reduce vibrations due to an unstable vertical frame (3 walls, triangular 35% infill)Required:M4x12 button head bolts and nuts for the gantry supportM4x16 Bolts (any kind) to replace the existing short bolts holding the interface.M4x12 Nut and bolt (any kind) to clamp the spool holder*(all nuts should have a 7mm distance from flat side to flat side)*(Bolt heads should be 4.1mm in diameter or less)*What I used (https://www.mightyape.co.nz/mn/buy/off-the-back-carbon-steel-socket-cap-bolt-nuts-500-pieces-7097355468859/)Instructions:ALL NUTS NEED TO BE PRESSED INTO PLACESpool Holder - Clamp around the existing holder using the nuts and bolts, attach the primary nut allowing a small gap (DO NOT clamp the filament roll), use the lock nut to keep the Contact nut in the desired position.Cam/Tool Bracket- No assembly required, I recommend printing in the upright position using the default tree supportsWaste Tubs- Place the frame retaining clips in hot water before attaching to allow flex (Creality text is optional, and must be glued onto bins)Filament Guide- Simply replace the existing extruder cable clamp (there is a…