cell holder vase mode

Description

This is a cell phone holder with two positions, one straighter and the other more inclined. The file was formatted for vase mode printing with a 1mm nozzle. A single outer layer is placed against the opposite layer, merging into one another without the need for layer joins or infill. Printing takes approximately 10 minutes. Attention: To function correctly, it must be printed with a 1mm nozzle, 1.2mm thickness, and 0.8mm layer height in VASE MODE. I used PETG at 240 degrees Celsius and a heated bed at 100 degrees Celsius. The challenge was to create a simple, seamless, quick-to-print, slim, and clean cell phone holder with more than one position.