Primus 1020/991 Storm Lantern replacement Knobs (Pre supported)

Description

Decorative, and as close to original (part number 6427) as possible, replacement knobs for the Primus 1020 and 991 storm lanterns, and similar (As with most retro Swedish storm lanterns, many parts are interchangeable; these might fit on other models as well). NOTE: The product is sold under license from Primus (Primus-Silva Sweden AB). I am not an official retailer. All rights to the trademark belong to Primus-Silva Sweden AB. These parts have metal inserts that are needed for them to fit the lanterns. The fit is pretty tight, but I would recommend gluing them in place. It's designed/prototyped with resin and not filament printing, so bear in mind I haven't confirmed success with filament. I do doubt that it would be a problem though, since it prints excellently in resin on 0,05 mm layer height (your average FDM printer with 0,1 mm would in this case half the "resolution"). The presupported lychee slicer file(s) are designed for resin 3d printing; filament will require you to support and slice additional files.