Snap-Fit Picture Frame

Description

This is a super easy picture frame to print that hold your photos well. Easily Snaps together and stays together. There is a standing Frame and a Magnet frame. I will also add a stand for landscape photos, I currently only have the stand for portrait. Everything prints support free. Models will have to reorientated, but it should be pretty easy to figure out the correct orientation. All pieces snap together besides the magnet ring, the magnet ring will need to be glued on. There is a circle on the back side of the frame insert for easy alignment. The magnetic frame is slightly thicker than the standing frame so that it will sit flush. However, you could use either frame if you don't mind the framed picture sticking out about 5mm from whatever the magnet is stuck to. The magnets this is made for are found at walmart in the craft aisle. HelloHobby Magnetic Buttons/19mm Diameter/52pack