Duck Coaster!

Description

I’ve always loved the duck aesthetic… so naturally the next thought was: why not make a coaster with a duck attached to it? This playful design blends function with a bit of character. The coaster features a beveled edge to help catch condensation and small spills, while the slightly raised duck silhouette adds just enough detail without interfering with how your cup sits — flat, stable, and practical. The attached duck head gives it a little personality on your desk or table without being over the top. It’s simple, clean, and just fun to have sitting around. Print Note: As with most multi-color prints involving white filament, some color bleed can occur. A purge tower is recommended for the cleanest results. You can also purge into infill or into another object on the build plate if preferred. The included 3MF is set up with a purge tower for simplicity and consistent results. Finishing Tip: For extra grip and surface protection, consider adding an adhesive cork backing or small rubber feet to the bottom.