Pop It 3x3 Square

Description

Important Note - Please Read: There are 2 distinct bubble files. You will need to print 2 of the same file for this design. The thinner one is best for higher stiffness TPU, and the thicker one is best for lower stiffness TPU. If you don't know the difference, print the thinner bubble file for best results This is another pop-it version. I call this the square, desk toy variant. You will need to print two of the pop bubble sheets. The red/black bubbles are printed in TPU, and the white casing is printed in PLA on a textured PEI build plate. I think it makes the surface look cool. You will need pliers to close the case into the locked/sealed position. I wanted it so I could throw it around and drop it without it breaking open. Method for increasing product durability - under adult supervision for under 18! pre-heat convection oven to 350F or 177C, put bubble plates only on a flat metal tray (for 35 seconds - 45 seconds in oven for thin type, or 45 seconds - 1 min for regular type), immediately remove with oven mitts (heat protection), and cool-off to room temperature (1 min and 45 seconds) in the refrigerator, immediately. This method will increase softness and possibly also the durability of the design