Hypercube Front Bed Frame Alignment Bracket - Retro - Remix

Description

Remixed From https://www.thingiverse.com/thing:2248266 I have a few different approaches. V4: For this idea: Smooth Two Color Inlay 3D Print Using Cura Z Hop (https://www.youtube.com/watch?v=0Sla-vIsvh4) Hungarian blogpost: Többszínű 3D nyomtatás (https://zen3d.hu/tobbszinu-3d-nyomtatas-kreativitassal/) V3: It is similar to V2, but it's easier to print without warping. You can print (without support) by the caption looking sideways. V2: Fits into the extrusion more precisely. The letters are not very deep, just 0.5mm. (the center of the letters is not connected to the model, which in V1) You can print (without support) by the caption looking sideways. It's current orientation. V1: It is easier to screw than the original because it has no bottom side. It is easier to print with the caption down (without support) because the center of the letters is connected to the model on the first layer. Zen3D (https://zen3d.eu/)