Modular Dice Tower

Description

Left a space for a 3.5x5x1/8th inch acryllic sheet to slide in so you can see your dice rolling. My printer bed is kinda finnicky and small so I had to split it into 3 parts. Print top x2, and bottom x1, stack them. I suppose you could go with top x1 if you wanted a lower profile tower. I reccomend supergluing them together. Top V2 is because the tabs to make the pieces fit together didnt print well on my printer, they came off when i was removing the support material. Bottom V2 adds a slope to roll the dice out from the tower for if you are rolling many at a time. Also removes the bar across the top. Top V3 adds some slopes to try and reduce support material.