Holder - Spray Cans

Description

This is an initial test build published to solicit feedback for improvement.Design Concept:A series of tool and accessory holders that can be attached to modular mount plates for various brands track / wall systems, or mounted directly to the wall.Printing Instructions:The minimum tested infill for most parts was 10% grid pattern with 3 wall loops using PLA+ filament. 15-20% gyroid infill is recommended for better durability, or performing selective reinforcement of key areas (hooks, fingers, etc.) during slicing. PLA+ works for most of the tool holders for light duty, but PETG or better is recommended.Assembly:The series is designed to use M4 screws and nuts, with a M4x16mm being used for most of the modules in the series.Specifically ISO7380 Button Head M4 -0.7 x 16mm or M4 - 0.7 x 12mm screws were used for the design.Other M4 screw head types should generally work as well, but they may required the use of a washer depending on how they sit in the recessed area of the tool plates.The M4x16mm screws that I personally am using are made by IEXCELL and can be found on Amazon.Revision 1 - Initial Design / Prototype