Fidget satisfying 3 clicks

Description

Hello,I’d like to present my new project, the “Fidget Clicker”, with 3 levels of clicks.This design is extremely satisfying, because when you use the right filament it produces a very nice clicking sound.After printing, you should insert the pin by pressing it firmly into the hole, no worries it doesn’t fall out.A few notes:Not every filament will give a clear clicking effect; some are quite slippery, so the effect may be weaker.Never remove the print from the build plate before it cools down, otherwise you may damage the spring and the pressure will not be correct.Use only dry filament for the best effect.Print without supports.By bending the spring, you can remove the lever at an angle by pushing it towards the spring. With a bit of practice you can easily take it out, so you can always swap the lever printed from a different filament and test the result.Boost MeIf you like my work, please leave a comment, like, or boost — it will make me very happy :).BoostBest regards, and enjoy!