Stacking Gaming Controller Holderby Noobsauce

Description

COPPIED:Currently tested and works nicely with:XBOX One controller (With battery modpack replacement)XBOX Elite Series 2 controller (without back paddles)Nintendo Switch single Joycon grips (https://www.***********.com/thing:3246275)Nintendo Switch Official Joycon grip (Only on the top piece/holder, otherwise it does not fit properly.)A Nintendo Switch console (on the top holder)PlayStation 4 Dualshock controller (doesn't fit well but does stay on as long as there are no bumps against the holder)How to build:All the pieces are force/friction set. If you want it to be stronger or to not come apart, using superglue is a valid solution that I will be testing.) Each file will contain the amount of units that you need, such as 2 arms in one print. If requested, I can push out an STL file for one arm in an event of if one breaks.Steps 3 and 4 are for if you are printing this to hold more than one controller. If you plan to only hold one controller, skip those prints/steps and go onto print/step 5.The base (CH_Base) is the bottom piece, giving enough desk space to make sure it doesn't fall on it's own while holding controllers.Next will be the arms for the base (CH-Arms_Base), they will be pushed into the base to make it to either the desk or just the bottom of the CH_Base part.Then (if you will be holding more than 1 controller) the Arm Brace (CH-Arm Brace). This is used to make sure the arms do not stray too far apart from each other in-between stacks, causing…