Airsoft/Paintball Mask Ventilator system

Description

These are the printable components for an anti-fog ventilation system that permanently attaches to an airsoft or paintball mask.Please note that this is intended to be a permanent installation and requires a hole to be cut into the mask itself, in the vicinity of the left or right cheek.Additional necessary materials include:standard aquarium air hosewirea 50mm blower motora switcha power source.a little bit of elbow grease, creativity and (in my case) a sewing awl and soldering iron. Possibly a small drill, and of course various lengths of 3M screws, washers and nuts.