Vertical Blind replacement hook

Description

Over the years the little plastic hooks that are at the top rail, which hold the vertical blind get brittle in the sun and can sometimes break. On some units you cannot buy just one hook and have to purchase a whole new rail. Even with the replacement versions it is a hard job as you have to take the whole rail down to perform repairs etc. My simple solution is a new hook which can be glued (I use Superglue, but you can use Epoxy) in place of the broken hook. Best printed in white PLA for strength, only takes about 4 minutes to print, (print off a couple and keep them spare in case of further damage) I have used this a couple of times so thought I would post this on the site. Hope you find it of use.