turbonator

Description

https://www.youtube.com/shorts/G7bdZ21smU4 ATTENTION! THIS ONLY WORKS WITH MY RIFLED BARREL LINER AND CANNOT BE SCALED UP OR DOWN. this one is a novelty. its complex and has many parts so please don't download if you don't have some mechanical aptitude. this is heavy and will likely break on the first launch, if you understand all that and still want to build it to tinker with or make as a shelf ornament please follow the build instructions and watch the video for assembly. REQUIRED: qnty 2 608 bearings 1 m8 bolt 30mm long 1 clean all brims or print imperfections from all parts, 2 press the bearings into both pockets in the rotor, remove seals and grease from bearings first. 3 the m8 x 30mm bolt will pass through the stator and both bearings then screw into the threaded hole in the tail. if the bolt doesent want to thread into the tail, use oil and heat the bolt so it softens and melts into the hole. tighten until snug, and be sure the rotor spins freely, not crooked or rubbing anything, assemble the fins by pushing the pins through the hinges. ensure they open freely and easily. if you dont want to destroy the model shoot into something soft like a bed sheet hung on a string or something like that.