Olight PL3R Valkyrie Protector

Description

This design is compatible with the Olight PL3R Valkyrie. It may be compatible with the PL3 Valkyrie but I have not tested the fitment. The protector will fit into weapon light bearing holsters providing the holster is adjustable. I have tested the Deadly Customs DC4 series Universal Olight PL-3 Kydex Signature Series Holster I have based the design off my successful sight kill flash as not only are they BB resistant but a popular design (https://cults3d.com/en/3d-model/game/lpvo-kill-flash-scope-protector & https://cults3d.com/en/3d-model/game/1x22-kill-flash-scope-protector). I have not been able to test the print to the same standards however it has held up to 5 shots point blank in the same location at 1.2j with 0.4g BBs before failure. The design has a 3mm air gap to the front glass with vent holes around the exterior to prevent thermal build-up and damage to both the torches and the print. The protector is a tight friction fit, allowing for the protector to be swapped when damaged while not falling off during use. When removing the protector be careful to twist clockwise to prevent unscrewing the torch lens. When using PAHT-CF the design resists the head from the torches without deforming retaining the integrity. I tested using the Odin S at full power for >15 minutes with no warping or weakening. Disclaimer; Always wear appropriate eye protection when handling airsoft replicas. Replace the protector after being shot or after extended periods being exposed to sunlight…