CR-10 Fan Mod 0.8mm Shorter v2 (Reinforced Screw Mounts) - fortheloveofrc420

Description

I found this fan duct on thingiverse and wanted to print it out (mine broke). After looking around this one seems like a good fit.I may make this a collection of fan mods i find.this is a re-mix from another file and the original creators link is also included.here is the info from the page itselfSummaryThis is a minor revision to Gabriel3DCaster's Creality CR-10 Fan Mod 0.8mm shorter. My original fan duct broke at the screw mounts. When I ran Gabriel3DCaster's, I broke the fan mounts again just while cleaning it up after pulling off the printer. I decided to add a little extra reinforcement to the outside of these screw mounts as additional insurance.If you find this helpful, please give it a like. By all means, please give Gabriel3DCaster a like and a tip for his efforts in designing the original. If you haven't been able to find exactly what you need, again, check Gabriel3DCaster's page as he has a few renditions of this fan duct.Gabriel3DCastehttps://www.thingiverse.com/thing:2814127Below are the settings that Gabriel3DCaster recommended in his original version of this fan mod.Print SettingsPrinter brand:CrealityPrinter:CR-10Rafts:NoSupports:NoResolution:0.1 mmInfill:10%Notes:This part has small details so it is better to print it with an high resolution (0.1mm works well).I recommend you to use a brim to avoid warping.second fan duct oemhttps://www.thingiverse.com/thing:2754529