Cpap Tabletop stand - Zoson

Description

The hexagonal tubes allow for vertical layer lines so you won't have layer separation if too much weight is placed on it. I had make a slip ring with the layers going the opposite direction to help prevent splitting when fitting the tube onto the base or each other. I just glued the ring to the very bottom of the tube.The base is sized to fit around the base of the ResMed Airsense 11 machine, but will probably work for a wide range of devices. The tube can be scaled in the ‘height’ direction to shorten or lengthen the height above the machine if needed.Print SettingsSupports are needed just for the top of the tube that inserts into the other tube. I set from print bed onlyI printed in PETG so I can use it while camping, PLA will work fine if it's not going to be anywhere hot