Snowman Candy Dispenser - 3dmpro

Description

The Snowman Candy Dispenser is a simple design, with its tray position sustained by a single rubber band. Easy to assemble, the dispenser has been broken up into several parts for the main body, head, snackChamber, bottom Top, and bottom base. Other parts include the core elements for the dispensing of candy and a few options to customize the head and face of the snowman. Standing approximately 250mm tall and 140mm at the base, if printed at 100%, the dispenser is an easy print. Most parts can be printed flat or on their flattest end, without supports. A few come with custom supports or are easily printed using standard slicer support options. .The dispenser can be scaled down without negatively impacting assembly and performance, as long as all part are scaled equally. Avoid scaling down further than 60%, as smaller part will become to weak for proper functionality. An image of an early test print shows the complete test assembly, despite stringing issues from wood fill filament that I was testing at the time...Print suggested for a full snowman :1 head with or without face1 carrot nose2 coal eyes1 snack chamber (chest)1 body btm top1 body btm base1 candyLever or shovelHead1 lever shaft1 snack door2 door hinge1 catch trayOne small rubber band (several to test different lengths) is needed to keep the candy door in a closed position beneath the candy chamber. It should to large enough to stretch at least 32mm with some tension, but not overly tight. It needs to stretch a bit…