LVDS Controller Box by Billy Tail

Description

LVDS Controller Box This is about 192mm width so a larger 3D printer is required. PLEASE NOTE Cables to VDU MONITOR and Back light in VDU MONITOR will need to be extended using these boxes. Design that will also allow the Back Light control PCB to be fitted, may still need some tweaking. Files :- Main_Box_LVDS_Controller_Box__Backlight.stl Back_Plate_LVDS_Controller_Box__Backlight.stl Seven_Buttons_LVDS_Controller_Box__Backlight.stl I have just added some stand off for small speakers, these speakers do not go flush against the inside surface. The speakers have made other changes Back light standoff so the speakers should fit. Here is a YouTube Play list relating to thishttps://www.youtube.com/playlist?list=PLUqt0sTiXUDe-o4b8O-j9MhNI2uV1qTq1 Low-voltage differential signaling, or LVDS, also known as TIA/EIA-644,. LVDS is a differential signaling system, meaning that it transmits information as the difference between the voltages on a pair of wires; the two wire voltages are compared at the receiver. In a typical implementation, the transmitter injects a constant current of 3.5 mA into the wires, with the direction of current determining the digital logic level. The current passes through a termination resistor of about 100 to 120 ohms (matched to the cable's characteristic impedance to reduce reflections) at the receiving end, and then returns in the opposite direction via the other wire. From Ohm's law, the voltage difference across the resistor is therefore about 350 mV…