Bubbler Bong (perculated)

Description

This bubbler is designed to take a 10mm diameter glass pipe to quickly turn it into an advanced water-pipe to make your smoking experience far more enjoyable. No matter what your smoking through it! :) This is an all in one print Though i advise printing it by pausing the print at certain times and swapping out to a transparent filament so that you can see the water levels in the bong and in the peculator to ensure you are getting the most out of it. Key features: the pipe holder is tapered to get a good air tight grip on the pipe edges The pipe holder is connected to a line that takes in the smoke and bubbles through 78 tiny square holes to create maximum bubbles and emit a much softer bubbling noise to be discrete. a three arm tree peculator is in the middle with 24 bubble holes on each arm to cool the smoke even further making for a much smoother hit. Printed in PLA then annealed in an oven @ 70 degrees Celsius (158 Fahrenheit) for 30 minutes so it better holds water. May also be printed in PETG. fits glass pipe diameter 10mm. Made in Sketch-Up