Sacrificial Arcane Pylon

Description

Does your evil wizard, lich, warlock, or necromancer have some captive NPC sacrifices they need to offer up to a demon lord? This sacrificial arcane pylon will have them sacrificed IN STYLE! Includes a built-in recess for standard medium-sized creature round bases, an arcane crystal which can be installed on top, and a built in compartment in the underside to house wiring and batteries to LIGHT THIS BAD BOY UP! The pylon itself prints great with no supports. I printed mine at .2mm layer height. For the crystal, I used a translucent purple filament. I printed them one at a time with a brim only. Your mileage may very, but I was able to get three crystals that printed perfectIy out of 5 total attempts. I wouldn't suggest trying to print more than one at a time because if one snaps off, it will end up getting pulled into the others and ruin them as well. If you can't get a good print with just a brim, you may need to add some kind of supports. I was hesitant to because I wanted to keep the surfaces as blemish free as possible. I used this set of lights from Amazon (Govee Fairy Lights): https://www.amazon.com/gp/product/B07HJ54Y3Q/ref=ppxyodtbasintitleo05_s00?ie=UTF8&psc=1 I clipped off all but two of the LEDs and fed them up through the hole in the pylon, then into the crystal. Then I put a couple dots of superglue in the crystal recess on the top of the pylon and glued the crystal and pylon together. The battery compartment and wiring fits up inside the base (leaving the…