Dice Maker Ring Mold V2

Description

Have you downloaded either my Smooth Dice Maker Ring Mold or faceted Dice Maker Ring Mold? Are you tired of using little plastic gems for registration and having to cut out outer keyways when making the lid? Have I got a model for you! With the addition of a part to make registration and little nubs on the ring mold for keyways, the Mark 2 is a marked improvement on the original ring molds! The Registration pinwheel can be scaled to fit around your dice if needed. Directions for use: To use, print the model, clamp the flat ends, add hot glue to the seams on the inside, cover one side with contact paper, add your dice masters and registration pinwheel, add silicone and cure. To make the top of your new dice mold, take the bottom mold, remove from the ring, flip over, take out registration items, spray with mold release, and place back in the ring and add silicone. This ring is 4 inches in diameter and fits an entire set of dice masters.