Camping Light (like Devos Lightranger)

Description

Light designed to light up a campsite or something similar. Can mount on a standard Tripod, or hang from a line, or just sit on a table or some other surface. Light faces are individually controlled as well as a master switch. Recharges from a 12V supply (car power port, solar panel, etc). Can power other 12V devices and has a USB port for charging whatever else. Special instructions: Pause the Base to put the nut in. Print the hooks with 4 perimeters and pause the lid to install them during the last few layers of the print. Change filament on the Riser near the end to TPU if desired for the feet/bumpers at the top. Screw in 2x M3-10 screws into the holes of each Light Box and tighten them to fit snuggly into the base. This is what they rotate around. Solder up 4x ~4" lead on the negative terminal of the battery pack, or if you prefer to use a large wire to solder onto the circuit board and break it out to the 4 wires that will run to the lights. Do similar with the positive lead but use the wires that come with the rocker switches. Wire up the lights in parallel. Add ~3" wires to those included with the rocker switches on the positive side. Solder up the last negative wire routed nicely to each Light Box. It is recommended to test each side at this point. Do this for all 4 sides and then glue on the riser. Parts List: PETG used: https://amzn.to/3D3mycg Lights (need two sets): https://amzn.to/3pzsS8f Battery Pack (disassembled): https://amzn.to/3NDuHZL Rocker Switches…