Lawn Jarts - Squid Graham

Description

Old Jart fin replacement from TPU, uses 0.8mm nozzle on the CRM4, 1.0mm line width.Tried using other materials but they had a tendency to shatter during use.Included .3mf for CRM4, 1.0mm line width .20mm layer height. Only reason it isn't listed in the right area is because I use orcaslicer now.*Updated 6/27/25: Added V2 model, which features a support part to allow for cleaner and more reliable prints. This prints connected to the rear of the fins, which can be trimmed off after printing using a knife or filament-wire cutter. After a few prints, the stringing between fins seemed unavoidable due to the way TPU prints, so the added support allows retraction to always occur in-between the support model and the jart fins, which connects the two while eliminating nearly all stringing defects, thus making part cleanup easier. This does use a little bit more material, but parts look much cleaner.