Cell Structure Lamp 2

説明

A simple ambient light :-) The light source is an Arduino Nano and 6 NeoPixels once again (the cheapest way to make an light source). If you like to know more about these NeoPixels you can visit the AdaFruit website at : https://learn.adafruit.com/adafruit-neopixel-uberguide/arduino-library-use I used an example of AdaFruit and modified it a bit. I just want the LED's to slowly change colors. I included the sketch and the AdaFruit library in the ZIP file. Also included a simple wiring diagram. The power supply is a phone charger (at least 1A) The dimension of this lamp is 90x90x90 mm and printed in green PLA except for the diffuser. The diffuser is printed in translucent PET-G. I have two types. A flat one and one that is printed using the “spiral outer contour mode”. You can see them side by side in one of the pictures. On this picture you can also see that I did not succeed printing the “spiral outer countour”one without warping. To prevent this more wall layers should be used. But then lesser light will come trough. Although it warped I personally still like this diffuser. If you print the “spiral outer contour” one you will have to cut out a small peace to make room for the micro USB connector of the Arduino. The flat on is printed as normal and you can decide for yourself how thick. I just used 3 layers, each 0.2mm thick. It's also possible to make the diffuser from other materials like paper etc. Anyways I included pictures with the flat and with the “spiral outer…