Laundry detergent dispenser

説明

Would you like to support my work? :) Check out my full catalogue (https://wonderl.ink/@gazzaladra) with exclusives, early access and commercial licenses. A fully 3d printed laundry detergent dispenser. It comes with a 100 ml cup, and you can freely adjust flow and dosage. The capacity is 2.4 L. The designs comes with a whirl to loosen the powder and crush crumbs to prevent the mechanism from clogging up. There are two sizes of whirls provided. If the smaller one leaves a tunnel of detergent stuck inside, use the bigger one. The file of the cup is provided with the spout on the right side, for left-handed people. If you are right-handed, mirror it in the slicer before printing. Important: This design does not work well with natural soap products unfortunately! I have tried to make extra versions for this specific use case, but the consistency will potentially result in a tunnel formation that even the big swirl can’t help with. Regular store-bought powder works great, but very unprocessed laundry soap not. Instructions - Print all parts - Place the insert onto the bottom - Insert the shaft into the stopper. (This is a press fit, if it is too loose, use a bit of glue here) - Place the stopper onto the insert - Add the top - Add your whirl onto the shaft from above - Place the lid Usage - Place the cup - Move the stopper to the left (closed) - Fill up the top with detergent powder - Move the stopper to the right to open and increase flow the further you push - The cup is 100…