Orange Pi Lite - Case

Orange Pi Lite - Case

無料 STL 収納・整理
  • 12 閲覧

このモデルは Thingiverse で公開されています。ファイル・画像・ライセンス情報は元の作者に帰属します。

Thingiverse で見る ↗

説明

A case for Orange Pi Lite, I use it for OctoPrint.It has a hole at the top that is tight enough to hold the antenna in place. It is a tight fit, no need for screws. And as you can see from the images the camera interface, GPIO pins, IR receiver and reset button are not usable. You might want to add four legs at the bottom to allow air to flow in, if you do a lot of RAM access, at least for OctoPrint this is not necessary.

About this model

Orange Pi Lite - Case is a 無料 3D model in the 収納・整理 category, shared by the Thingiverse community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Thingiverse. Use the button above to open the original page and download it.

類似モデル